Annitori QS Pro Quickshifter 4.00

For use with the QS PRO 1 and QS PRO 2 Annitori Racing Quickshifters:

1. Ensure that Bluetooth is enabled on your iOS device.
2. Start your motorcycle with the app closed. It is crucial to start your machine before opening the app so that the Bluetooth on the shifter can begin searching when you connect to the Annitori App.
3. After starting the bike, open the app. You will first see an image of our QS PRO, followed by the settings page on the left. Tap "SCAN" at the top left corner to initiate the search for the shifter.
4. If a QS PRO shifter is on and within range, a list will populate on the screen.
5. Select "QS PRO" or "QS PRO 2" to establish a connection between the app and the shifter.
6. Upon successful connection between the app and the shifter, you will see a screen indicating "Found, Click Read" in the status bar.
7. Please note that specific default settings are incorrect for our shifter. Inspect whether there are no direction indicators chosen, Sensitivity set to 5, Kill Time at 1ms, and RFX at 1. These are not appropriate settings for our device. Properly reading your QS PRO involves correct settings reflecting those on your shifter.
8. Click the center "READ" button. It may take a moment to retrieve data from the processor; if not, press "READ" again. The displayed information will appear on the left side of the screen.
9. When read correctly and accurately, the STATUS will show as "Ready." The Firmware version will be displayed, Sensitivity, Kill Time, and RFX values will be realistic, confirming a successful connection.
10. If uncertain, restart the process by exiting the app. Restarting takes only 10 seconds. After any changes or app usage, it is strongly recommended to completely exit the app to ensure a fresh start. Contact us for assistance if needed.
11. You are now prepared to adjust your QS PRO settings.
12. Upon initial use, the shifter comes preset with both directions enabled, 60 Sensitivity, 55ms Kill Time, and RFX at 18. Verify these settings initially; if not set as stated, adjust and upload them as base values.
13. NOTE: RFX should remain at 18 unless directed otherwise by our Customer Service after troubleshooting instructions.
14. Making changes is now straightforward:
PUSH (right to enable, left to disable) PULL (Switch right to enable, left to disable) Kill time – touch to display all kill time values in milliseconds. Choose your desired kill time. Sensitivity – touch to reveal options. A sensitivity of 10 requires more pressure for activation; 80 denotes very light pressure.